[โ€“] 1 point 2 years ago (1 child)

May not help at all, but one thing I noticed with my prints was that if I removed it before the bed cooled, it would often warp. I've since left it until it cools to room temperature and have got much better results.

Does it warp and lift from the base plate during the print, or does it stay stuck down? The former could be because of lack of adhesive and a raft/brim/glue may help, but the latter may just be lifting it off too early.

  • source
  • [โ€“] 4 points 2 years ago*

    On places like Bluesky, most articles, videos or news content Iโ€™d share would have more to do with how much I trust the person posting or sharing it than with its main body of content. I figure that someone I value has read it, and so I skip it, because reading it would feel like work and I have to deal with enough of that as it is.

    Not to mention, "You won't believe this one cool thing!" type headlines (like this one) are classic clickbaiting, and nobody wants to read a 10 page article that's basically just advertising.

  • source
  • parent
  • context
  • [โ€“] 14 points 2 years ago (6 children)

    On a tangent, is it just me, or has there been a notable uptick in this type of question? Feels a lot like astroturfing, but so far as I can see there's been no malicious intent

  • source
  • [โ€“] 2 points 2 years ago

    Depending on the country, your tax laws may also let you get the full cost of job related education and conferences back. I was lucky enough that my employment funded the bulk for me, but in Australia it's a solid way to keep learning once you're in the field you're after.

  • source
  • parent
  • context
  • view more: next โ€บ