72
Carving some cove profiling in some arches on columbarium panels (lemmy.world)
submitted 2 years ago* (last edited 2 years ago) by to c/woodworking@lemmy.ca
3 comments fedilink hide all child comments
 

I've got 20 of these to carve out, and I've only done a smidgen of carving before. Luckily my boss trusts me enough with his antique carving tools

Before I started carving:

all 3 comments

sorted by: hot top controversial new old
[–] 5 points 2 years ago

Looks good!

  • permalink
  • fedilink
  • source
    •
    [–] 3 points 2 years ago (1 child)

    What kind of tools do you use for something like this?

  • permalink
  • fedilink
  • source
  • hideshow 2 child comments
    •
  • [–] [S] 5 points 2 years ago*

    Not sure if you mean all of it, or just the carving part, but I used a 1" hole saw on a drill press in the small opening, and a 3" hole saw for the two larger rounds. Then spindle sand the edges. Then use a jig saw and chisel to clean up the small opening. Next is a router with a cove bit with a bearing. Then using a carving knife and carving gouge to get the shape. Hope that helps!

  • permalink
  • fedilink
  • source
  • parent