Those sections of extrusion are being pulled away from the print as the nozzle moves, because for whatever reason they are not adhering to the rest of the print properly.

Increase print temperature, reduce print speed, or reduce travel move speeds.

Also a sanity check, look at your slicer's output preview and ensure nothing about that model is causing it to freak out and attempt to print in midair...

You're sure it's the first layer as well as others? The print bed side looks pretty cleanly pressed against the build plate, it seems unlikely you'd have issues unless there is some major deviations in your bed leveling. It mostly looks like the gcode had it try to print in the air/with nothing for it to stick on.

As others have pointed out this is pretty common for inner circles and you may have to find a way to tweak the print settings or the design to be more printable. You can look through the preview layer by layer and check the tooling path for anything that would obviously not work.

That being said, if you'd like to share the 3mf file I wouldn't mind poking at it later... 3mf is what Bambu slicer uses isn't it?

Try enabling avoiding crossing perimeters in slicer.

Check nozzle cleanliness - remove any junkus from outside.

See if slower print speed helps?

Is the room temp high enough with no cold drafts? I live in a cold area and have had print problems with the room being to cold.

That looks like multiboard snaps. They are specifically designed for 3 walls, .2 layer height and .4 nozzle.

I had problems that looked like that from z hop. The nozzle was dragging. Enabling zhop (or increasing it a tiny bit) can stop the print head from dragging and leaving filament wisps.

it's not being adhesive, trying a 5+ degrees might help. try setting drawing the outside parameters first.

It looks like that's your first layer? Poor bed adhesion coupled with a slight under extrusion might be doing it. You could also try to slow down your first layer dramatically (50% or more slower)