846
Leaked Email Shows Elon Musk Demanding "Sub 10 Micron Accuracy ” Cybertruck Parts (jalopnik.com)
submitted 2 years ago by to c/technology@lemmy.world
354 comments fedilink hide all child comments
 

Tesla is facing issues with the bare metal construction of the Cybertruck, which Elon Musk warned was as tricky to do as making Lego bricks

you are viewing a single comment's thread
view the rest of the comments
[–] 9 points 2 years ago (1 child)

Micron, as in 0.00004"? Yes you COULD hold it, with second ops and temp control.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [+] 6 points 2 years ago* (last edited 2 years ago) (1 child)
    [deleted]
  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 11 points 2 years ago (1 child)

    The total tolerance is .0004". In equally disposed bilateral tolerancing it will be +-.0002".

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 4 points 2 years ago (2 children)

    Eh, if someone tells me to reduce a tolerance from 5 to 10 thou at work, it's understood that it's +/-5 and 10. I don't think I've ever heard someone use the full range of a tolerance in conversation. If the tolerance isn't bilateral, it would be said like plus 5, minus zero. Anyways, +/- .0005" is our standard tolerance on the span of all dowel hole pairs.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 4 child comments
    •
  • [–] 2 points 2 years ago* (last edited 2 years ago) (1 child)

    Bilateral tolerancing is a Machinist's first introduction to tolerancing so it's no surprise to run that as default. And I suppose GD&T is not heavily used where you are.

    If you're given a parallelism tolerance of 10 micron are you assuming that to be +-10 micron? True position? Angularity of 5 thou? Etc... The only feature control that could be interpreted as bilateral by default is profile and it's still communicated by its total tolerance.

    Simple +- tolerancing isn't the industry standard anymore. And if Tesla prints are anything like spaceX ones... It's basically all GD&T and minimal title block tolerances.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 1 point 2 years ago

    I use GD&T on all my drawings, including 100% of my hole callouts. However I'm one of the more enthusiastic adopters of ASME Y14.5 at the place I work. Therefore, I get what your saying regarding the tolerance range, but since most of my coworkers are still relying on block tolerances, I'll refer to a .010" positional tolerance as a "+/- .005" equivalent" in conversation so there is no miscommunication. I can see how this is not the norm.

  • permalink
  • fedilink
  • source
  • parent
  • [+] 1 point 2 years ago* (last edited 2 years ago) (1 child)
    [deleted]
  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •