▲ 511 ▼ Print failed successfully! (lemmy.world) submitted 2 years ago by spckls@lemmy.world to c/3dprinting@lemmy.world 37 comments fedilink hide all child comments Turned on retraction speed to 11 and i guess it wore down the filament at one part but then managed to push it after some 10 minutes of spaghetti 👌
[–] Bloodwoodsrisen@lemmy.tf 6 points 2 years ago (2 children) Is it still a 20mm cube? permalink fedilink source hideshow 4 child comments replies: [–] spckls@lemmy.world [S] 9 points 2 years ago This was max acceleration / max speed test, it’s a 30mm cube (scaled) permalink fedilink source parent [–] marcos@lemmy.world 3 points 2 years ago Not really a cube, that's certain. But unless it's losing steps, the printer just can't make that top layer in any other height. permalink fedilink source parent
[–] spckls@lemmy.world [S] 9 points 2 years ago This was max acceleration / max speed test, it’s a 30mm cube (scaled) permalink fedilink source parent
[–] marcos@lemmy.world 3 points 2 years ago Not really a cube, that's certain. But unless it's losing steps, the printer just can't make that top layer in any other height. permalink fedilink source parent
