1428
Cyan Low, Rule (slrpnk.net)
submitted 2 years ago by to c/196@lemmy.blahaj.zone
106 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[–] 16 points 2 years ago (5 children)

Yeah, but try printing out your kid's book report on one.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 10 child comments
    •
  • [–] 15 points 2 years ago (1 child)

    Totally doable, use a multicolor printer and print it like 3 layers thick - you'll get thin flexible plastic sheets.

    Not actually practical, but totally doable lol

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 3 points 2 years ago* (last edited 2 years ago) (1 child)

    Just do a midprint filament swap... Looking at getting into TPU at the moment, it might actually be a fun way to have my kid hand something short in. 3 layers of white, 0.12mm per layer, swap to black and print 3 layers more. I'd be concerned about stringing and delamination. But it's pretty close to the heated bed, so mostly stringing. Fuckit we're going to try!

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 2 points 2 years ago (1 child)

    Your now going to do this and report back right?

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 5 points 2 years ago

    Totally could

    You'd need two filament colors, and it would take a while just to do one page. If it's a five pager then it could take hours. And then you'd have to turn in a big stack of plastic slabs. If you accidentally print a typo-

    ... Yeah, point taken

  • permalink
  • fedilink
  • source
  • parent