10
Replacing a gravel bike front fork (lemmy.world)
submitted 8 months ago by to c/bicycles@lemmy.ca
6 comments fedilink hide all child comments
 

I am looking for some advice on how to go about finding replacement front fork for my gravel bike. I bought my bike second hand and it was already a few years old at the time I believe which might explain why it is hard to come by a replacement part. The bike in question is a Fuji sportif le one.0.

I am looking for a fork which:

  • has a steerer length of ~10 3/4 inches
  • has a steerer diam of 1 1/8 inches
  • fits a tapered bearing
  • will fit a 9x100 QR axle
  • has a post mount disc brake interface
  • will fit my 28x700c wheels and tires

I have been put onto this ENVE fork which looks a bit too good to be true.

If anyone has tips for looking for new forks, things that I have missed, or other suggestions I would be all ears. Every time I think I may have found a solution I end up learning something new about why it would not work for me.

you are viewing a single comment's thread
view the rest of the comments
[–] 2 points 8 months ago (1 child)

Not sure if you posted a pic or not, I'm not seeing one. A tapered steerer tube transitions from 1 1/8" to 1.5" in the bottom few inches of the steerer tube. Both tapered and straight steerer tubes can be a tiny bit wider at the very bottom inch or so where the crown race is pressed on, or some forks will have a crown race molded into into the bottom of the steerer tube. Either way, measure the diameter of the steerer tube just above the crown race. If it is 28.6mm or 30mm, you have a straight steerer tube. If it is noticeably wider, it is tapered.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •