It worked for me

Couldn't a kid "borrow" their parent's ID for the age verification? Isn't it just as pointless today?

Ate the onion (¿ǝqʎɐɯ pǝɥɔʇᴉlƃ ɹo)

Pure luck!

🐅 Animal #470 🐦‍⬛ I figured it out in 2 guesses! 🟥🟩 🔥 1 | Avg. Guesses: 2

N

If you're sticking with Marlin, I've been very happy with the "professional" firmware. The configurator is pretty easy to set up if you change any hardware like a new bltouch or new hotend if that's your thing.

47

Don't bring religion into this!

In the V2, the other side is occupied by a screw holding the tensioner in, but I was told I could use a T-nut and that would save me a lot of headache

Thank you!!! I have a fear that this is the start of the dark dark path of having a full workshop.

I'm starting from no knowledge here, so all advice is great! Do you mean this stuff? Or should I get the aluminum version?

Okay, I have no clue what I'm doing but I did look up a little bit on tapping and think I might be able to try that. Of all the threads to strip I think I may have gotten lucky. The screw doesn't seem to do much other than keep the metal plate from sliding up and down (though I may be wrong) so I'm not too worried about strength I think.

What do you mean about the rod? Is this to buy a rod, cut it to size, use a die to thread it, and screw that in?

Is this a "good enough" tap? Looks like I'd need to get a wrench for it too?