That Janeway has a bloodlust that can never be sated.
Michael Bay
Haven't seen violet in a while.
The should definitely have object permanence by age 5
It's 3 letters and 4 numbers
Should lower US prices too I'd imagine. If the Chinese RAM is cheaper then demand drops for US RAM globally.
You can write GPL rust code, you can also write non-gpl rust code. Gnu coreutils are gpl, if I choose to write functionality compatible with coreutils from scratch in rust I can relicense that as I please (ie not GPL) OP is postulating the driver behind rust rewrites is not for the language features but to allow coreutils functionality to be relicensed as closed source software.
10 o'clock tea and elevenses could both reasonably fit the bill here I feel.
I've wanted to for years. I've tried to multiple times. Like I love computers and programming I can get absolutely lost in code for hours. For whatever reason when I start to look at networking my brain switches off and says nope. I can clean enough to hack what I need for the most part, but of I strive for any depth of knowledge on the subject my brain shuts down.
Hoping this article is the ticket.
XDA is pretty much slop these days.
Card sleeves are just a subset of wallets.
I'm making one at the minute.
First one done, everything seemed to work, assembly was relatively straightforward and the instructions were great.
Changes - buffer tubes were printed separately with variable layer height in Orca, I've read this helps feeding filament, settings:
Adaptive height 0.08, radius 4.
Triangle Lab kit only seems to come with long springs for the buffer tube, so you'll be building the long stroke version. I wasn't aware there were multiple versions so no loss. They are on the BoM though, so hopefully it saves someone else having to scour the instructions to see if the "missing springs" are needed.
I think I'll try printing the housings for the next one with support, some of the overhangs are a bit misshapen and had to be cleared out with a drill bit. This may still bite me further down the line when I need to fit the module to the base.
It seems like it shouldn't be too difficult to take apart if necessary.
I'd think about bending the solder tabs on the motors before soldering as well, it's a bit of a squeeze inside the housing and it's harder to bend them after.
Hopefully I'll get a second housing printed this week and at least another module assembled at the weekend.
I've just taken a quick look, I've not checked off the BOM yet, but motors, boards, PTFE tube and a collection of parts have arrived. There's a bit of a description/warning sheet and a link to a Google drive with it too. Will check out some more over the next couple of days.
view more:
next ›