5
Issues with failures (lemmy.world)
submitted 2 years ago by to c/3dprinting@lemmy.world
3 comments fedilink hide all child comments
 

Bambu X1C

Hatchbox ABS black and clear black

Been having a lot of failures lately with printing. Anyone else using hatchbox and having issues? Filament quality gone downhill?

Just got a kilo of black and it’s jammed up my print head four times. Switched from that to some clear black and I got some massive warping, 1/4” lift that popped my print (about 6”x3.5”) off with a spaghetti failure about halfway through. I’ve never had warping this bad.

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 1 point 2 years ago (1 child)

Well that’s too bad. I’ve been using them for years and they’ve been pretty consistent up until now. Might have to switch brands.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 2 points 2 years ago

    Yeah I’m honestly not sure. I haven’t read that many similar reports to the issues I’ve had, which usually means it’s not a widespread issue…but all I can do is speak to my own experiences. Who knows lol ¯_(ツ)_/¯

  • permalink
  • fedilink
  • source
  • parent