34
Running into inconsistent extrusion when printing a circular model (lemmy.blahaj.zone)
submitted 2 years ago* (last edited 2 years ago) by to c/3dprinting@lemmy.world
7 comments fedilink hide all child comments
 

I have been trying for many hours now to print this circular model, but have been running into inconsistent extrusion and stringing. just before printing this, I successfully printed a set of Hextraction tiles, so I'm not really sure what the issue is. I also printed this model successfully in the past with the same settings.

I am using a Sovol SV06 with stock firmware, and PLA with the hotend at 195° C.

I also did a full calibration to see if that would fix the issue, and it did not.

you are viewing a single comment's thread
view the rest of the comments
[–] 8 points 2 years ago (1 child)

It looks like underextrusion at speed. It might be a clog or you might want to try a higher hotend temperature. PLA can have inconsistent ideal temperatures even with the same brand due to different colors and additives between batches and 185 is on the low side.

  • permalink
  • fedilink
  • source
  • hideshow 2 child comments
    •