31
PLA warping during print (feddit.org)
submitted 2 years ago by to c/3dprinting@lemmy.world
14 comments fedilink hide all child comments
 

I am using the Creality ender 3 v3 SE with eSuns PLA+ in black. The recommended printing temperature is 205-220 and I am printing at 210. The bed is set to 65°. When I print somewhat flat parts. The edges warp off the plate, while the printer is running and the plate is still hot. Until a few days ago it worked perfectly and I don't know what I am doing different.

It is always only the first few layers, and the print never moves, so that the printer would make spaghetti, its just the edges that lift of a few millimeters.

you are viewing a single comment's thread
view the rest of the comments
[–] 6 points 2 years ago

This is correct, shrinking forces are fighting against bed ashesion. I use 60C and then drop it to 55 tho. On top of that you need clean bed and revisit first layer squish

  • permalink
  • fedilink
  • source
  • parent