▲ 511 ▼ Print failed successfully! (lemmy.world) submitted 2 years ago by spckls@lemmy.world to c/3dprinting@lemmy.world 37 comments fedilink hide all child comments Turned on retraction speed to 11 and i guess it wore down the filament at one part but then managed to push it after some 10 minutes of spaghetti 👌
[+] FredericChopin_@feddit.uk 1 point 2 years ago* (last edited 2 years ago) (1 child) [deleted] permalink fedilink source parent hideshow 2 child comments replies: [–] marcos@lemmy.world 2 points 2 years ago I have one of those servo sensors that use a microswitch at the end. The printer has a sturdy frame build from extruded aluminum. That probably makes a lot of difference. I can take the printer, move it into some other surface, turn it on and print, without leveling issues. Before it I had a wooden one without autoleveling. That one needed leveling before each print. permalink fedilink source parent
[–] marcos@lemmy.world 2 points 2 years ago I have one of those servo sensors that use a microswitch at the end. The printer has a sturdy frame build from extruded aluminum. That probably makes a lot of difference. I can take the printer, move it into some other surface, turn it on and print, without leveling issues. Before it I had a wooden one without autoleveling. That one needed leveling before each print. permalink fedilink source parent
