20
Why does filament not stick to the glass? (midwest.social)
submitted 2 years ago by to c/3dprinting@lemmy.ml
27 comments fedilink hide all child comments
 

You can see where around corners and even some straight runs it is peeling up. I'm running first layer at an agonizing 15 mm/s. Using hatchbox pla filament, just dried in dehydrator. 200° nozzle and 70° bed. The glass is freshly cleaned with soap and water, I just did several atomic pulls, I've trammed at different heights using a feeler gauge, and absolutely nothing is working. Any one have any ideas?

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 1 point 2 years ago (1 child)

I was able to get it printing, but doing some calibration confirms that adjusting z offset made the bottom layer better. What's the point in z offset specifically, vs just changing the gap when tramming or the initial layer height?

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 2 points 2 years ago*

    If your printer has a touch sensor, then raising/lowering the entire bed has no effect on the first layer. The Z offset defines the difference between the touch point and the first layer.

    I think most people calibrate the Z offset for 0.2 mm, and then never change the first layer height.

    Edit: oops, this thread is a month old.

  • permalink
  • fedilink
  • source
  • parent