189
One month ago, I didn't really know what 3D printing was. Yesterday, I designed in FreeCAD my first model and printed it. What an amazing experience. (lemmy.world)
submitted 2 years ago* by to c/3dprinting@lemmy.world
61 comments fedilink hide all child comments
 

I still have no idea what I'm doing really. Just too determined to give up I guess, and it's been such fun. Anyway I made a guitar pedal light switch cover. Still a lot of work to do, and every time I look at FreeCAD the wrong way, the model breaks, but it's been a fun experience nonetheless.

On a side note, anybody have any idea why the face of the model is rough textured, while the foot switch on the lower half is flawless?

you are viewing a single comment's thread
view the rest of the comments
[–] 1 point 2 years ago (1 child)

Not level, Z height. Z height shows as lines spaced too far apart. Could also be under-extruding.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 1 point 2 years ago (1 child)

    Sure, on the first layer. We can’t see the first layer here, only the top layer, so it can’t be the z height.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 1 point 2 years ago* (1 child)

    As far as I know, z height affects all layers. Check out https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-how-do-i-print-this-printing-help/rough-top-layer-surface-on-new-prints-after-recent-z-axis-calibration/ and see if that makes any sense.

    This has happened to me before - a messed up z height will affect all layers because the squish isn't there at any layer. You'll always have that difference in height between the surface being built and the nozzle no matter what layer you're on.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 1 point 2 years ago*

    Skimming that post shows a lot of people saying that first layer doesn’t affect top layer. What is your definition of z height? We may have a definition issue on our hands here. To me, it means the distance between the nozzle and the bed on the first layer.

    I’d be with you on the underextrusion though if the very top layer didn’t look so good. I would bet OP doesn’t have enough layers on top of the infill leading to an artifact that resembles underextrusion.

  • permalink
  • fedilink
  • source
  • parent