992
They're so spacious (lemmy.world)
submitted 1 month ago by [M] to c/memes@lemmy.world
182 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[–] 34 points 1 month ago (3 children)

It's one of the benefits of a bucket seat, and you'll note front seats have a bucket shape both on the back and the bottom. This does a LOT to keep a human in place, especially if the seatbelt is holding the human down into the bucket. Lots of surface area on the side of the leg and torso for the bucket shape. OTOH with a bench seat there's nothing at all keeping the human in place, there's just the 3 places where the strap crosses the human and those don't do very much. Seat belts are designed to keep you down in the seat.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 6 child comments
    •
  • [–] 13 points 1 month ago* (5 children)

    Most passenger cars don't really have bucket seats. Bucket seats like in race cars have hard, deep structural sides, whereas in passenger cars they're just soft pillows in a very shallow bucket shape. This is obviously because getting in and out of an actual bucket seat is difficult and consumers don't like it. Because the pillows are soft, they're not going to stop you from sliding out in an impact.

    I imagine the vaguely bucket shape of modern passenger cars has basically nothing to do with safety, at least not in the "stops you from flying sideways out of your seat" sense, and is mostly just a comfort thing.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 10 child comments
    •
  • [–] 16 points 1 month ago

    Having been in accidents in both a bench seat and regular car seat. I can say the car seat did a much better job of keeping my ass in place. Though having the center console to brace against may also have played a part in that.

  • permalink
  • fedilink
  • source
  • parent
  • [–] 13 points 1 month ago

    Those are both bucket seats, just to different degrees.

    Imagine a camera placed where the spine or leg is looking at the side of the seat. Look at how much exposed surface area faces the camera. Let's call that surface area the 'side restraint component'. (IE, if the side panel comes 'up' out of the seat 2", and extends out 4", the side restraint component is 2").

    On a seat belt, you've got about 2" x 4" surface area on each side. So 8 square inches on each side. That's all a bench seat gives you.

    On that car seat you've got about 2.5" x 8" on the back, plus an average of let's call it 2.5" x 4" on the seat. So that's about 30 square inches on each side.

    On the racing seat you've got about 14" x 20", but cut in half as a triangle, and let's say the shoulder bit fills in the missing part by the belt opening. So call that 140 square inches per side.

    The car seat may be designed for comfort, but the side bolsters do have a restraint effect.

  • permalink
  • fedilink
  • source
  • parent
  • [–] 5 points 1 month ago

    And yet I find them uncomfortable as hell! For long drives anyway. The headrest bends your head forward, so then you’re forced to recline the seat to counteract it. Even your arms go a bit forward due to the bucket shape. I get the safety reasons, just can’t stand the bad posture.

  • permalink
  • fedilink
  • source
  • parent
  • [–] 2 points 1 month ago

    Honda bucket seats are much deeper than say a random US model. Not talking about racing buckets.

    I drove a Mercedes a few months ago for a work rental. Terrible hard flat seats like sitting on a park bench

  • permalink
  • fedilink
  • source
  • parent