10
my models keep getting knocked off. what to do? (lm.boing.icu)
submitted 2 years ago by to c/3dprinting@lemmy.ml
10 comments fedilink hide all child comments
 

Hi, I'm new to printing. I got myself a Kobra 2 and it was printing fine when I got it. But recently it started to knock the prints off at random times. I have done several recalibrations, adjusted the Z offset up and down. What I have noticed is that all of these models seem to have a small overflow of material which I'm guessing the nozzle is bumping into. But I have no idea what causes it. I'll post the latest print that failed, there the extra material is more pronounced than usual. Any suggestions what I should adjust? (Btw I'm using Octoprint)

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 1 point 2 years ago

This already had a brim but it is quite ugly. The thing is I had the same failure while printing a bigger object like a Stormtrooper helmet. Randomly popped off the bed after like 2.5 hours

  • permalink
  • fedilink
  • source
  • parent