80
Question: Humidity controlled cabinet (lemmy.world)
submitted 5 months ago by to c/3dprinting@lemmy.world
28 comments fedilink hide all child comments
 

Hi all,

I'm doing an experiment with a cabinet for filament with a small dehumidifier in it. I can get it to sit at 35%, but not much lower. I've sealed the cabinet with foam tape, and dried most of the filament first.

Are there any tricks to help improve performance of the mini dehumidifier? Maybe adding more heat to the cabinet?

The goal would be to use Home Assistant and the humidity sensor to turn things on and off as needed.

Thanks!

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 2 points 5 months ago

Yea, I was curious about "limits". I'd like to be stable at 30% vs 35%, then I can keep the petg and tpu in the dryers and everything else in the cabinet.

I have a couple of mini heaters I was going to build into chamber heaters for the SV08 Max, so I may stick one of them in there to see what happens.

  • permalink
  • fedilink
  • source
  • parent