22
Does Prusas textured sheet...work at all? (sh.itjust.works)
submitted 6 months ago by to c/3dprinting@lemmy.world
51 comments fedilink hide all child comments
 

I've had a MK4S for over a week now, and 100% of the prints I've tried to make on the textured sheets have partially or totally failed. PLA prints beautifully on the smooth sheet, but PLA, PETG and ABS, I think I could print on the surface of a 10 inch tank of oil with more success than the textured sheet. Plastic doesn't stick to it. I've wiped it with isopopyl, I've washed it with dawn...it's a bad print surface and I want my money back.

you are viewing a single comment's thread
view the rest of the comments
[–] 4 points 6 months ago (1 child)

Its PEI, powder coated. Everything should stick to it with out any adhesives. Soap?

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] [S] -1 points 6 months ago (1 child)

    I've seen instructions saying to, and not to, wash it with soap and water. I have washed it with Dawn dish soap and warm water, I've wiped it off with isopropyl alcohol, doesn't fucking matter. Nothing sticks to it. When we're done with Greenland, we need to do Czechia.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 1 point 6 months ago* (1 child)

    Freedom soap and alot of hot water is all you need. If thats not enough and you havent invaded the bed in weird ways before its probably bad Start code or user error.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •