▲ 135 ▼ Finally finished my first RC car (lemmy.world) submitted 2 years ago by UserNotFound@lemmy.world to c/3dprinting@lemmy.world 9 comments fedilink hide all child comments I finally finished model 7 (Buggy) from 3dsets. It was fun to build, but mistake to take it in forest (one screw loose near one rear wheel).
[–] UserNotFound@lemmy.world [S] 2 points 2 years ago* (1 child) PLA: Prusament Lipstick Red (body) Polyterra Charcoal Black (chassis) Polyterra Fossil grey (inside) Filament PM(Czech brand) graphite black (seats) Filament PM white Filament PM Pearl Red (cage) Fillamentum Clear (for lights) ASA: Prusament Lipstick Red (for few parts) permalink fedilink source parent hideshow 2 child comments replies: [–] MrAnderson@feddit.nl 1 point 2 years ago (1 child) I wasn't expecting plain PLA! Are there any issues with warping due to heat from the motor? permalink fedilink source parent hideshow 2 child comments replies: [–] UserNotFound@lemmy.world [S] 1 point 2 years ago It's recommended to use PC or ASA for motor parts. I used ASA permalink fedilink source parent
[–] MrAnderson@feddit.nl 1 point 2 years ago (1 child) I wasn't expecting plain PLA! Are there any issues with warping due to heat from the motor? permalink fedilink source parent hideshow 2 child comments replies: [–] UserNotFound@lemmy.world [S] 1 point 2 years ago It's recommended to use PC or ASA for motor parts. I used ASA permalink fedilink source parent
[–] UserNotFound@lemmy.world [S] 1 point 2 years ago It's recommended to use PC or ASA for motor parts. I used ASA permalink fedilink source parent
