31
this thing look burned to you? (lemmy.ml)
submitted 9 months ago* (last edited 9 months ago) by to c/askelectronics@discuss.tchncs.de
18 comments fedilink hide all child comments
 

never had one of these, that's a capacitor, right? also don't know what capacitance this is, tried searching but came up short

edit: OK, since it's 1000V I guess this isn't electronics, askelectrics doesn't exist yet?

edit 2: top view

edit 3: the whole mess

(dogdammit lemmy, can't you tell me what image size isn't too large, I hafta guess?!)

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 4 points 9 months ago* (last edited 9 months ago) (2 children)

fuse OK. turns on, backlight works, image has lines all over and after a while (30 sec when left overnight off power, 10-15 secs when left a couple hours) it starts fading the image to black with the backlight still on. inspected visually all components, this is the only one that looks suspicious.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 4 child comments
    •
  • [–] 3 points 9 months ago

    And the end of the electrolytic cap looks okay? (The blue can). If that thing spit out over all the parts, maybe it can explain the mess.

    Otherwise, it feels like something is heating up in an undesired way. This could be something downstream of some filtering capacitor that is now dead?

    If you had a thermal camera, it would tell you a lot, but not necessarily point at the bad part. Can you get more run time with a fan? (Not a permanent solution)

  • permalink
  • fedilink
  • source
  • parent
  • [–] 2 points 9 months ago

    sounds like the tft panel connection is not good anymore? connection of the tft driver to the panel. maybe fpc directly soldered on driver board. device heats up and connection goes bad until fade to black?

  • permalink
  • fedilink
  • source
  • parent