21
Prusa Mk4 or Mk4s first layer issues (lemmy.sdf.org)
submitted 2 years ago* (last edited 2 years ago) by to c/3dprinting@lemmy.world
28 comments fedilink hide all child comments
 

Is anyone else having HORRIBLE problems with their Prusa Mk4 or Mk4S first layer quality...

My mk4s developed a problem that Prusa spent 3 months troubleshooting with me where the first layer is being laid down too close, and so filament blobs, then prints fail.

Eventually, they advance replaced my whole printer, and the new one had the exact same problem out of the box..

I managed to find a bug that was raised on github for this exact issue, with 22 other people registering "mee too" for the issue..

I'm just looking for some feedback from the wider community to see if any others have hit this problem?

you are viewing a single comment's thread
view the rest of the comments
[–] 1 point 2 years ago

On the new photo it’s obviously too close to the bed but consistently so. Looks like the defaults picked by prusa might not be the best. Try what they posted on github, manually change the Z offset in start g-code. Looks like (hopefully temporarily) you’re back to manually tweaking your Z height like a plebeian.

  • permalink
  • fedilink
  • source
  • parent